Thomas & Betts Connectors Based on Thomas & Betts Catalog Electronioc Interconnects European Edition 1998. Created 10.06.1999 Packages changed/corrected 22.02.2006 librarian@cadsoft.de <author>Created by librarian@cadsoft.de</author> THOMAS&BETTS H2M25RA29A >NAME >VALUE THOMAS&BETTS H2M25ST29x >NAME >VALUE THOMAS&BETTS H2R25RA29A >NAME >VALUE THOMAS&BETTS H2R25ST29x >NAME >VALUE THOMAS&BETTS H3M25RA29A >NAME >VALUE THOMAS&BETTS H5M25RA29A >NAME >VALUE THOMAS&BETTS H5R25RA29A >NAME >VALUE >NAME >VALUE >NAME D-Subminiatur Connector Source: Electronioc Interconnects European Edition 1998 Supply Symbols GND, VCC, 0V, +5V, -5V, etc. Please keep in mind, that these devices are necessary for the automatic wiring of the supply signals. The pin name defined in the symbol is identical to the net which is to be wired automatically. In this library the device names are the same as the pin names of the symbols, therefore the correct signal names appear next to the supply symbols in the schematic. <author>Created by librarian@cadsoft.de</author> >VALUE >VALUE SUPPLY SYMBOL SUPPLY SYMBOL DEC Edge Connectors and Parts PIN HEADER A >NAME >VALUE VV CONNECTOR A B >NAME >VALUE 40 VV UU LH Cinch Einbauprintbuchse, ( RCA Jack ) RM 7.5 x 10 mm Artikel-Nr.: 736880 - 49 Source: http://www.produktinfo.conrad.com/datenblaetter/725000-749999/736880-da-01-de-Cinch-Einbaubuchse.pdf >NAME >VALUE >VALUE >NAME >NAME >VALUE PIN HEADER RCA Jack Frames for Sheet and Layout Date: >LAST_DATE_TIME Sheet: >SHEET REV: TITLE: Document Number: >DRAWING_NAME FRAME LETTER landscape Jumpers <author>Created by librarian@cadsoft.de</author> JUMPER >NAME >VALUE >NAME >VALUE JUMPER Harting Connectors Low profile connectors, straight <author>Created by librarian@cadsoft.de</author> HARTING 1 2 >NAME >VALUE 26 >NAME >VALUE HARTING Tektonix 611 Connector Board